hello everyone ,

i have problem after closing wolfteam game i receive error memory cannot read problem


my memory is 2.00 GB and im afried that my laptop might crash if the error happen alot

i reinstall the game and the problem temporarely gone and started getting back again..


i also noticed that the more people join room during gamplay the more player move

slowley and the fire rate slow doen ????

can you make people in room 6 vs 6 and cancell 8 vs 8 so that player can play better and

faster.????  

zodi22 wrote:

hello everyone , i have problem after closing wolfteam game i receive error memory cannot read problem my memory is 2.00 GB and im afried that my laptop might crash if the error happen alot i reinstall the game and the problem temporarely gone and started getting back again.. i also noticed that the more people join room during gamplay the more player move slowley and the fire rate slow doen ???? can you make people in room 6 vs 6 and cancell 8 vs 8 so that player can play better and faster.????

hmm i havnt seen this kind of error before but i can give some advice...you could just join 4v4 or below games i mean no one forces you to join 8v8 just go to a game with 4v4 or 3v3 or 2v2 or 1v1 lol and also

I THINK that your problem is because you have a bad/no graphics card(unless your labtop is amazing and has one which i dought)

umm also make sure ALL other programs are closed and unneccesary applications are closed aswell if your using wireless setup a static ip

im rushing throught this post but ill post how to setup a static ip adress(THIS IS ONLY IF YOUR USING WIRELESS THOUGH!)

okay press start then select run>type cmd in the box that appears>a black window will open type in ipconfig/all and a list of numbers will appear leave that window open for a while>now on the bottom right corner of your screen there will be little icons click on the one with the computer and 3 lines>then press properties>in the general tab there should be a list that you can scroll through the bottom one should be "internet protocol (TCP/IP)"
click on it once and then select properties which will be right under it>next depending on what it said in the black box fill in the window that came up so for ip adress you would put your ip and so on and after you have filled everything out it should be setup just press apply and pray that your internet still works(it wont if you did it wrong xD)

*NOTE if you dont have 2 DNS servers shown in the black box just put the same exact 1 in the second box however instead change the last number heres an example

prefferd DNS server:192.168.1.254

alternate DNS server:192.168.1.250

notice how i only changed the last number

*ALSO REMEMBER TO TICK THE CIRCLES THAT SAY "use the following ip adress" and "use the following DNS server adresses"

FINALLY if everything is already filled in then you probably already have a static ip adress

PS.so if i didnt help as much as i could but i rushed through this...